White Stretch Plastisol Ink – Gallon – Spandex & 100% Polyester Fabrics

White Stretch Plastisol Ink is the white to match our Stretch line — a high-opacity, maximum-stretch white for spandex, Lycra and 4-way stretch fabric, direct print or a stretchy underbase. It cures cool at 290–310°F and stays super-stretch and bleed-resistant. CPSIA-compliant and phthalate-free, made in Hackensack, New Jersey.

Available by the gallon and larger. Heat cure. Made in the USA.

Also available in larger quantities — 30-gallon and 55-gallon drums; call 877-937-6400 for volume and discount pricing.

Features & benefits

• Maximum-stretch white — flexes with 4-way stretch, spandex and Lycra without cracking
• High opacity — bright, dense white; direct print or stretchy underbase
• Low cure (290–310°F) — runs cool; bleed-resistant on polyester
• CPSIA-compliant & phthalate-free — made in the USA

Always run a test print first. Before any production run, print and fully cure a test on your exact garment and check opacity, hand and wash-fastness. It's the best habit in the shop — if you're not sure on settings, call us at 877-937-6400 before you run the job.

What it prints on

• 100% polyester — jerseys, performance tees, athletic wear
• Spandex & performance blends — the stretch film moves with the fabric
• Poly blends & sublimated garments — prone to dye migration — the bleed blocker holds color back

Printing & curing

• Mesh: 110–160 for maximum opacity; up to 200+ for a lighter deposit
• Squeegee: 65, 75 or 80 durometer — or a 70/90/70 triple durometer
• Flash: 240–260°F between colors
• Cure: curing is a time-and-temperature process — bring the full ink film to 290–310°F (143–154°C); the low cure is what keeps polyester dyes from bleeding; confirm with a temp gun or donut probe, not dryer air temp

Recommended companion products

• Nylon Bond 289 Additive — mix into this ink to bond prints to nylon and other slick synthetics (catalyst; stir in a small amount, limited pot life, always test first).
• Quick Flash Reducer — thins for easier printing.
• Soft Hand Base — softer hand feel.
• UMX® Custom Color Match — send us your target color reference and we custom-mix the color for you (plastisol, solvent, UV & water-base).
• Cleanup: OPTI Wash 125 and OPTI Spot 303.

Safety, PPE & storage

• Wear nitrile gloves and safety glasses; avoid prolonged skin contact with uncured ink.
• Print with adequate ventilation; vent your dryer.
• Always stir before use.
• Storage & shelf life: keep sealed, out of sun. Shelf life 1–2 years. As an all-polyester low-cure ink, store at 60–80°F. In high heat expect container expansion — open carefully. Do not freeze.
• Refer to the Safety Data Sheet before use.

Compliance

CPSIA compliant (16 CFR 1303 <90 ppm; CPSIA §101 <100 ppm total lead) — safe for children's apparel. Phthalate-free.

⚠ WARNING (California Proposition 65): This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Questions?

Total Ink Solutions
200 South Newman Street, Unit 4 & 5
Hackensack, NJ 07601
Phone:877-937-6400 · Fax: 201-487-9620
Email: sales@totalinksolutions.com